Configure Network Authentication Screen - Toshiba e750 User Manual

Configure Network Authentication Screen

A wireless network can be added either when the network is detected, or
manually by entering settings information. To determine if authentication
Information is needed see your network administrator
Data encryption (WEP Enabled)
Click here to enable data encryption.
The Key is provided for me automatically:
Check here if you can obtain WEP key automatically from AP. Almost
case this function is used with 802.1X function. Default is "Enable".
Network Key (WEP key):
Enter the ASCII characters and symbols that correspond to the mode
selected.
Key Index:
This becomes enabled when WEP is selected. Select 1 - 4.
User's Manual
64 bits (ASCII)
5-digit ASCII characters or symbols can be entered in "Network
Key".
128 bits (ASCII)
13-digit ASCII characters or symbols can be entered in "Network
Key".
64 bits (HEX)
Hexadecimal 10-digit English letters and numerals can be entered
in "Network Key". Letters and numerals that can be entered are
0-9 and A(a) - F(f).
128 bits (HEX)
Hexadecimal 26-digit English letters and numerals can be entered
in "Network Key". Letters and numerals that can be entered are
0-9 and A(a) - F(f).
Wi-Fi (IEEE 802.11b) Wireless LAN
Check here to set WEP (Wired Equivalent
Privacy). Default is "Disable".
Check here to enable shared authentication
(Shared mode). Default is "Disable".
Check here if you can obtain WEP key
automatically from access point. Almost case
Default is "Enable".
In "Key" you enter the ASCII characters and
symbols corresponding to the selected WEP.
Select Key as transmit 1–4.
Check here to enable 802.1x authentication.
Default is "Enable".
Show the Properties when you can connect to
Access Point with 802.1x authentication.
Select EAP type. Default is "TLS(EAP-TLS".
8-8