Additional Information; Technical Specifications; Limited Warranty - ResMed Mirage Kidsta User Manual

61801r1.book Page 5 Friday, September 10, 2004 10:02 AM
A I
DDITIONAL NFORMATION
R H
EASSEMBLING THE
Note:
You do not need to disassemble the
headgear for cleaning. However, if you choose
to do so, the reassembly procedure is
explained in this section.
When disassembled, the headgear has four
parts:
A: Left strap, B: Middle strap,
C: Crossover buckle, D: Right strap
1 Lay out the four parts of the headgear as
shown in Figure F-1.
2 As shown in Figure F-2, thread the
straps BR and BL through the crossover
buckle (Part C).
3 Thread strap BR through the buckle on
Part A. Thread strap BL through the
buckle on Part D (Fig. F-3).
4 Thread the straps of Part A and Part D
through the buckles on Part B (Fig. F-4).
5 With the headgear clip facing down, fit
the headgear clip onto the hole on the
headgear. While pressing the headgear
tab down, rotate the headgear clip away
from the tab to lock it into place
(Fig. F-5). Repeat this with the other
headgear clip.
T S
ECHNICAL PECIFICATIONS
P –F C
RESSURE LOW URVE
See Figure A.
Note:
Translations are based on the English version in this guide. However, there may be minor
variations based on the disinfection/sterilisation procedures applicable in some countries.
ResMed has reviewed these changes and all procedures included here have been validated.
D
EAD
Dead space is the empty volume of the
EADGEAR
mask up to the swivel.
The dead space of the mask for all cushion
sizes is 81 mL.
R
EPLACEMENT
Part No.
61020
60013
61025
61026
60023
60024
60924
60925
60014
60926
60927
16570
16571
61011
L
IMITED
ResMed warrants that your ResMed mask
system, including its components: mask
frame, cushion, headgear, tubing and other
accessories ("Product") shall be free from
defects in material and workmanship for a
period of ninety (90) days from the date of
purchase by the initial consumer.
For further details refer to the Warranty.
S I
PACE NFORMATION
P
ARTS
Item
Headgear Assembly, Small
Cushion, Small
Headgear clip - blue (2 pk.)
Headgear clip - blue (10 pk.)
Crossover buckle - blue
Crossover buckle - blue
(10 pk.)
Mask Frame
Elbow Assembly
Swivel Assembly (10 pk.)
Inlet Tube and Swivel Assembly
Inlet Tube and Swivel Assembly
(10 pk.)
Ports cap (2 pk.)
Ports cap (10 pk.)
Mask System, Small
W
ARRANTY