Toshiba SD-V291 Owner's Manual page 19

Note: The S-video output and component video output transports the DVD-video signal exclusively and will deliver
enhanced DVD video picture performance.
Connecting to an audio system and TV equipped with S-video input/component video inputs
Signal flow
To S- To P /C To P /C
R R B
VIDEO VIDEO VIDEO
OUT OUT OUT
To P
To P
S-video cable (not supplied)
If you connect the DVD/VCR to your TV
with the DVD OUT jacks, select the
corresponding video input on your
television to watch DVD video discs.
Component video (ColorStream
Some TVs or monitors are equipped with component video inputs. Connecting to these inputs allows you to enjoy the
highest quality DVD picture playback.
Actual labels for component video inputs may vary depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, C
In some TVs or monitors, the color levels of the playback picture may be reduced slightly or the tint may change. In
such a case, adjust the TV or monitor for optimum performance.
Notes:
• Refer to the owner's manual of the connected equipment as well.
• When you connect the DVD/VCR to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before making any connections.
• If you place the DVD/VCR near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD/
VCR away from the tuner and radio.
• The output sound of the DVD/VCR has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening
level. Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the DVD/VCR's power cord. If you leave the amplifier power on, the
speakers may be damaged.
• An S-Video connection is superior to Video (Yellow) output. Use this method for DVD playback when the connected television
has S-Video input, and does not have component video inputs.
To ANALOG
(white)
AUDIO OUT
(red)
To wall outlet
To Y
B
VIDEO
OUT
Component video
cable (not supplied)
To Y video input
C video input
B/ B
C video input
R/ R
To S-video input
TV or monitor with
ColorStream
component video inputs
®
) outputs/inputs
When you make this connection, set the S-VIDEO/
COMPONENT Video selector switch to the desired
position.
And also you must select the corresponding video
input on your TV.
Audio cable (not supplied)
To audio inputs of
the amplifier
®
(red) (white)
Audio system
, C )
B R
19