General Safety Considerations; Safety Earth Ground; Before Applying Power - Agilent Technologies PNA Series Installation And Quick Start Manual

Safety, Regulatory, and Environmental Information

General Safety Considerations

General Safety Considerations

Safety Earth Ground

The Mains wiring and connectors shall be compatible with the
CAUTION
connector used in the premise electrical system. Failure to ensure
adequate earth grounding by not using the correct components may
cause product damage and serious injury.

Before Applying Power

WARNING If this product is not used as specified, the protection provided by
the equipment could be impaired. This product must be used in a
normal condition (in which all means for protection are intact) only.
If an instrument handle is damaged, you should replace it
WARNING
immediately. Damaged handles can break while you are moving or
lifting the instrument and cause personal injury or damage to the
instrument.
CAUTION This instrument has autoranging line voltage input. Be sure the supply
voltage is within the specified range.
CAUTION This product is designed for use in Installation Category II and Pollution
Degree 2 per IEC 61010-1:2001 and 664 respectively.
CAUTION Ventilation Requirements: When installing the product in a cabinet, the
convection into and out of the product must not be restricted. The ambient
temperature (outside the cabinet) must be less than the maximum operating
temperature of the instrument by 4 °C for every 100 watts dissipated in the
cabinet. If the total power dissipated in the cabinet is greater than 800 watts,
then forced convection must be used.
The measuring terminals on this instrument are designed to be used with
CAUTION
external signals described in Measurement Category I, but NOT with
external signals described in Categories II, III, and IV. The input of this
instrument cannot be connected to the mains.
4-2 E8356-90001