Table of Contents
Advertisement
8. To avoid a hazard due to inadvertent resetting of the terminal cut-out, the hand dryer must
not be supplied through an external switching device, such as a timer or to a circuit that is
regularly switched on / off. Each dryer must have it's own dedicated circuit. Move all field
wiring away from moving parts within the dryer.
9. The NEC (National Electrical Code) and / or CEC (Canadian Electrical Code) require
installation fittings with smooth rounded surfaces for protection of power supply cables.
10. Store and dispose of solvent-based materials, and materials used with solvent-based
materials, in accordance with requirements of local authorities having jurisdiction.
Warning: Mercury HAZARD. Caution must be taken not to break GERMICIDAL UVC bulbs
during installation and since these bulbs contain a small amount of mercury which can
cause injury if inhaled or ingested. For more information on clean up and disposal, see
www.lamprecycle.org.
DANGER!
Failure to properly ground this unit could result in severe electrical shock and / or death.
This dryer should be properly grounded for safe operation. An identified ground
connection point is supplied with dryer wall plate.
Ultraviolet (UVC) radiation hazard. Over exposure will cause significant eye damage and
may cause skin damage. Do not look into UV light source.
7. INSTALLATION
1. Go to the circuit panel to place breaker or fuse in the OFF position, never attempt
to install, clean interior or service unit without first shutting off its power source.
2. Use Table 2 to determine recommended mounting height. Select a mounting location for
the dryer where no reflection surfaces or objects (such as a wash basin) are directly under
the optical sensor. The optical sensor is visible from the bottom of the dryer.
Classic & Jym
ADA & Ultra
Advertisement
Table of Contents
