Electrical Specifications; Electrical Ratings - Vortex Ultra HS Installation And Operating Manual

5. ELECTRICAL SPECIFICATIONS

TABLE 1
MODELS
ULTRA HA
ADA HS
CLASSIC HS
JYM HS
6. SAFEGUARDS
1. Always place breaker on OFF position before installing, disconnecting or otherwise
servicing the hand dryer. Failure to disconnect the power source before installation or
servicing can result in serious injury or death from electrical shock.
2. Failure to properly ground the unit could result in serious injury and/or death from
severe electrical shock. The hand dryer must be properly grounded for safe operation.
An identified ground connection point is supplied on the hand dryer's wall plate. A
GFCI protection is recommended protection in wet or damp locations or as required by
local construction codes.
3. Risk of fire, personal injury or property damage is possible if local codes, or safety
recommendations are not followed.
4. Installation and servicing should only be performed by qualified electrical technicians.
5. Use only the electrical power (voltage & frequency) specified for the dryer being
installed. See Table 1 Electrical Specifications.
6. Connect the hand dryer to the nearest distribution panel. The fixed wiring must
include a disconnection means complying with local wiring codes. To limit voltage
drops, and insure efficient operation, use No.12 AWG wire or larger as required by
local electrical codes.
7. Always connect to a branch circuit breaker or fuse protection with an electrical rating
greater than the model's rated amperage shown in Table 1 – Electrical Specifications, in
accordance with the NEC (National Electrical Code) and / or CEC (Canadian Electrical Code).
TYPE

ELECTRICAL RATINGS

Automatic 110 / 115 VAC 1130W 60 Hz
230 / 240 VAC
Automatic 110 / 115 VAC 1130W 60 Hz
230 / 240 VAC
Automatic 110 / 115 VAC 1130W 60 Hz
230 / 240 VAC
Automatic 110 / 115 VAC 1130W 60 Hz
230 / 115 VAC
CERTIFICATION