Toshiba M200/M205 User Manual page 188

188
Keeping Your Files Safe
Using passwords in the Windows® operating system
To register master and user passwords in System Setup:
1 Click Start, then click Shutdown, and click OK.
The computer shuts down.
2 Hold down the
button until the on/off light on the system indicator panel
illuminates (green) for approximately one second. When
the following message appears on the screen: "Check
system, Then press [F1] key," press
The System Setup screen appears.
3 Press
screen.
4 Press the spacebar to select Master + User password
mode.
5 Press the down arrow key to move to the Master
Password section. You must register a Master Password
first.
6 Press the spacebar, then type a password of 1 to 16
characters and press
of letters and numbers in your password.
7 When System Setup prompts you to verify the password,
type it again and press
If the two passwords match, System Setup displays:
for both User and Master passwords. If the two passwords do
not match, an error message appears. Repeat steps 6 and 7 to
enter the password again.
8 Press
9 When System Setup prompts you to confirm your
change, Press
key and press and hold the power
Esc
to move to the HDD PASSWORD section on the
H
to save the change.
End
.
Y
. You may use any combination
Enter
.
Enter
.
F1
Registered