Troubleshooting Tips; Remote Control Operation - RCA RT2906 User Manual

Hide thumbs Also See for RT2906:
Table of Contents

Advertisement

Troubleshooting Tips

AM / FM Operation
STEREO indicator is off in FM mode
Adjust the antenna.
Press MONO / ST button to insure you are not outputting in mono.
The signal is Mono. Severe hum or noise.
The signal is too weak. Connect an external antenna.
There is interference to FM reception.
Turn off other electrical unit (e.g. DVD, BD, CD player) near the unit.

Remote Control Operation

The remote control does not operate the unit.
No batteries installed (included with your system). Install the batteries before attempting to operate the
remote. Be sure to match the + and - ends of each battery to the symbols shown in the remote battery
compartment.
The batteries are weak. Replace all batteries.
The remote is not pointed at the remote control sensor on the main unit or there is an obstacle between
the remote and the main unit.
The remote control is too far from the main unit, move closer.
General
No audio.
Make sure the speakers are connected.
Check the input connections.
Check the power cord connections.
Make sure MUTE is off.
Make sure the digital setting (optical, coaxial or analog) is correct.
Check that the headphone is not inserted.
No audio from one channel.
Check the speaker level setting.
Check the speaker wire or external source cable connections.
Noise occurs when the TV is turned on.
The TV is too close to the audio system.
Not getting audio from all speakers.
Check your Surround Mode setting (under Advanced Sound Control section of this book). Your Home
Theater has a number of different SURROUND MODE settings, it defaults to modes most suited to the
type of audio content being played – however you can change these settings. Some of these modes,
(such as DOLBY DIGITAL, and Dolby PROLOGIC II), will cause all speakers to be active, while other modes,
(such as STEREO and 3-STEREO), will cause your rear speakers to be inactive. You can always test your
Home Theater amplifier - and each speaker, by using the built-in TEST TONE generator (press TEST TONE
button on remote control).
- 18 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents