Electrolux FGMO205KFA Service Manual page 25

Procedure
Letter
G
MONITOR SWITCH TEST
1. Disconnect the power supply cord, and then remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor. (See Warnings and Instructions on page 3-1)
4. Before performing this test, make sure that the secondary interlock switch and the primary
interlock relay are operating properly, according to the Switch Test Procedure. Disconnect the
wire lead from the monitor switch (COM) terminal. Check the monitor switch operation by
using the ohmmeter as follows. When the door is open, the meter should indicate a closed
circuit. When the monitor switch actuator is pushed by a screwdriver through the lower latch
hole on the front plate of the oven cavity with the door opened (in this condition the plunger of
the monitor switch is pushed in), the meter should indicate an open circuit. If improper
operation is indicated, the switch may be defective. After testing the monitor switch, reconnect
wire lead to monitor switch (COM) terminal and check continuity of monitor circuit.
5. Reconnect all leads removed from components during testing.
6. Reinstall the outer case (cabinet).
7. Reconnect the power supply cord after the outer case is installed.
8. Run the oven and check all functions.
H
TOUCH CONTROL PANEL ASSEMBLY TEST
The touch control panel consists of circuits including semiconductors such as LSI, ICs, etc.
Therefore, unlike conventional microwave ovens, proper maintenance cannot be performed with only
a voltmeter and ohmmeter. In this service manual, the touch control panel assembly is divided into
two units, Control Unit and Key Unit, and troubleshooting by unit replacement is described
according to the symptoms indicated.
Before testing,
1. Disconnect power supply cord, and remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor. (See Warnings and Instructions on page 3-1)
4. Disconnect the leads to the primary of the power transformer.
5. Ensure that these leads remain isolated from other components and oven chassis by using
insulation tape.
Continued on next page.
Section 3 Troubleshooting and Testing
Component Test
3-7