Package Contents
Installing the stand
Before attaching the stand, place a soft cloth on a flat, stable surface, and then place the product onto the cloth so that the screen
is facing downwards.
Caution: 1. When placing the product on a flat surface, you can damage the projection on the camera.
2. To prevent damage, place the monitor down gently & carefully.
3. Do not remove the stopper pin before installing the base.
1
Turn the stand in the direction
indicated by the arrow.
4
Caution:
Do not remove the stopper
pin before completely installing
the stand's base. Otherwise it may
cause physical injury.
BN68-02401C-01
Quick Setup Guide
Unpack the product and check if all of the following
contents have been included. Store the packaging
box in case you need to move the product at a
later stage.
A 30-second stand-by time is required after turning
the product on.
2
Make sure that the stand has
been properly turned in the right
direction.
5
Turn the connecting screw at the
bottom of the stand fully so that it
is completely secured.
3
Push the base into the product's
stand in the direction indicated by
the arrow.
6
After installation of the base is
complete, stand the product up.
• Remove the stopper pin.
• Adjust the height of the screen
to your specifications.