2.2.14 INSTALLING OR REPLACING A HOT-SWAP DRIVE
Do not proceed before reading and understanding the "Safety Precautions" section of this chapter and "Read Me First".
Note: The diagrams below are relevant for servers with 3.5-inch hard drive configuration only.
To remove a 3.5-inch hot-swap drive, do the following:
1. Gently push the release latch of the hot-swap drive (See Figure below) to open the handle of the drive.
2. Rotate and pull the handle to slide the drive out of the chassis.
To reinstall, reverse the steps above.
Special Note: Install the hot-swap drives into the available bays in the order numbered in the diagrams below. Install dummy trays in all
vacant hot-swap drive bays.
0
1
2
Pushing the release latch of a 3.5-inch hot-swap drive
Removing a 3.5-inch hot-swap drive
3
4
5
Order of installation for 3.5-inch hot-swap drives
6
7
8
9
10
11
31