Siemens Gigaset C100 Quick Start Manual

How is a Repeater registered to a Siemens Gigaset C100 base?
Preparation with the C100 handset
1. Select display key "Menu"
2. Scroll thru menu to "Base Settings" option
3. Confirm with display key
4. Scroll thru menu to "Additional Features" option
5. Confirm with display key
6. Scroll thru menu to "Repeater Mode" option
Confirm with key
Press key again to turn repeater mode on
The C100 base station and handset are ready for operation
NB: Repeater is not yet connected to power socket.
Registration procedure for Repeater
1. Plug the Repeaters main plug into the socket for 1 - 5 seconds, then pull it out.
Then plug it in again and leave it plugged.
The LED on the Repeater will flash slowly after the start.
2. Press the paging key on the base station, and hold it down for 3 seconds.
The LED on the Repeater will flash rapidly.
3.
Press the off-hook key
continuously illuminated now), then enter the Repeater number via the
keypad. Ie: Select number 2, 3, 4, 5, 6 or 7
NB: A number must be assigned to the Repeater (Select 2 to 7, for a
maximum of 6 Repeaters). Please write down the number, because each
number can only be assigned one time, when operating multiple Repeaters.
These numbers are independant of the internal numbers of the handset.
The LED on the Repeater blinks the same number of times as the Repeater
number entered and then remains continuously illuminated.
4. Press the star key
.
.
.
on the C100 handset (the LED on the Repeater is
at the C100 handset to conclude the registration