Finding A Device; Loop Loading; Turbo And Non Turbo Modes - Honeywell GENT S-Quad Data And Installation

S-Quad
Finding an S-Quad
device
The 'find device' is a function that gives a visual or audible
indication at the respective S-Quad device on a loop
circuit.
Press the Menu On/Off button and then
a.
[Test/Eng] .
b. Select [Loop] and then [Find Dev].
Now enter a Loop card number to select the loop
c.
circuit.
Select [Start] and type in a device number
d.
(usually device 1 is entered).
Select [Enter]. The display shows the device
e.
and loop number.
Number 1 on Loop 1
Press [Next] to find the next device on the loop
f.
and at any stage if the previous device needs to
be found then select [Previous].
A found device will provide visual or audible indication:
¨
On any S-Quad device there will be a flashing
indication given by the local LED.
¨
An S-Quad with Sounder, but without speech, will
cause the Sounder to output pulsed tone
¨
An S-Quad with Strobe will cause the strobe to
operate.
¨
An S-Quad with Speech will cause a tone
followed by announcement of a test message:
"This is a test message no action is required"

Loop loading

The 'Battery Standby Calculator' tool is avilable via Gentexpert
website. The tool must be used to accurately determine the loop
loading and to ensure the devices installed on each loop are
within the maximum allowed and will meet the control panel's
standby requirement.
4188-779 issue 10_12/13_S-Quad _Part 2
Description & Commissioning
Turbo and Non Turbo
Modes
The S-Quads can output in turbo and/or in non turbo modes.
When the panel commands a low or high tone output at
S-Quads, if configured during commissioning, the S-Quad will
output turbo and/or non turbo tones. The high and low FAB
mappings are used to change the tone output of the S-Quad
sounder. The turbo mode outputs a waveform with a basic
frequency that is the same frequency as the resonant frequency
of the S-Quad piezo. The non turbo mode outputs modulated
turbo waveform.
Turbo square wave
Turbo high tone
Turbo low tone - high output
Turbo low tone
Turbo rich high tone
Turbo rich low tone
No. Description
0 Turbo square wave
1 Turbo high tone
2 Turbo low tone - high output
3 Turbo low tone
4 Turbo rich high tone
5 Turbo rich low tone
8 Non-Turbo square wave
9 Non-Turbo high tone
10 Non-Turbo low tone - high output
11 Non-Turbo low tone
12 Non-Turbo rich high tone
13 Non-Turbo rich low tone
"
The volume levels and power requirements of
the S-Quads operating in turbo mode are significantly
higher than in non-turbo mode.
Non-Turbo square wave
Non-Turbo high tone (Default)
Non-Turbo low tone - high output
Non-Turbo low tone (Default)
Non-Turbo rich high tone
Non-Turbo rich low tone
13