Tuner; Tuning To Radio Stations; Storing Radio Stations; Tuning To Preset Stations - Philips FW-R8 User Manual

TUNER

STANDBY
ON
CD 1
CD 2
CD 3
- R8
FW
DISPLAY
MIC
LEV EL
MIC

Tuning to radio stations

1 Press TUNER to select the tuner.
is scrolled.
y
2 Press TUNER again to select the desired waveband.
y The selected waveband is displayed.
3 Keep à SEARCH or á SEARCH (à or á on the remote
control) pressed for more than a half second.
The selected waveband and
y
The radio tunes to a station with sufficient signal strength.
4 Repeat searching until you find the desired station.
• To tune to a weak station, briefly press à SEARCH or
á SEARCH (à or á on the remote control) as often as
necessary for optimum reception.

Storing radio stations

It is possible to store up to 40 radio stations. Stations can be
selected and programmed automatically or you can do that
yourself. Programming will overwrite your former presets
starting from the last active preset station. After programming
the last stored preset station will be tuned.
Automatic programming
If no preset is tuned, automatic programming starts at preset
number one.
1 Follow steps 1 and 2 of "Tuning to radio stations".
26
AN ALO G
DIG ITA L /
AU X
TU NE R
OR
iR SE NS
K/ TI M
CL OC
CD TE XT
E MIN I HIF I SYS TEM
CD REC ORD ABL
LO SE
OP EN /C
are displayed.
2 Keep PROG (PROGRAM on the remote control) pressed for
more than 2 seconds.
is displayed,
y
preset number in the music calendar start blinking.
All available radio stations for the selected waveband are
y
stored automatically.
PROG
the waveband and the frequency of the last preset station
are displayed briefly.
• To store radio stations for another waveband, repeat steps
1–2. Make sure to select the next available preset number
first before proceeding, otherwise already programmed
radio stations may be erased.
• To exit the automatic programming, press PROG (PROGRAM
on the remote control).
Note: Strong stations will always automatically be programmed
first, followed by the weak stations.
Manual programming
1 Follow steps 1 and 2 of "Tuning to radio stations".
2 Keep PROG (PROGRAM on the remote control) pressed for
less than 2 seconds.
and the current preset number in the music
y
PROG
calendar start flashing.
3 Press à SEARCH or á SEARCH (à or á on the remote
control) to tune to the desired radio station.
• To allocate the radio station to another preset number,
rotate í JOG CONTROL ë (pressí or ë on the
remote control).
4 Press YES to confirm the setting.
goes off, the preset number, the waveband and
y
PROG
the frequency of the preset station are displayed.
• To exit manual programming, press PROG (PROGRAM on
the remote control).

Tuning to preset stations

• Use í JOG CONTROL ë (í or ë on the remote control)
until the preset number of the desired station is displayed.
and the current
PROG
goes off, the preset number,