Mounting Method - Whirlpool HC338 Use, Care And Installation Manual

1. Rear mounting (2 brackets are pre-installed)
Use 2 screws and 2 washers to secure the hood to the wall.
(HC338 / HC768 / HC638 / HE568 / HE438 See FIG.1, HE2421 See FIG.2,
HC646 See FIG.3)
696mm
FIG.1
2. Top mounting
Use 4 wooden screws and 4 washers to secure the hood to the bottom of the
cabinet. Lift hood onto screws located on cabinet bottom and lock into place.
Make sure all 4 key-holes cover the screws. Tighten each screw to secure
hood to cabinet.
(HC338 / HC768 / HC638 / HE568 / HE438 See FIG.4, HE2421 See FIG.5,
HC646 See FIG.6)
Stick the two round rubber stands on the sides of hood's top(see FIG.7).
(Note: Make sure all 4 key-holes cover the screws and each screw was
tightened. Otherwise, there will be potential risk of machine falling down.)
M
OUNTING
FIG.4
FIG.6
M
ETHOD
586mm
FIG.2
4
878mm
FIG.3
FIG.5
FIG.7