Raymarine ST60 Owner's Handbook Manual page 25

12
The transducer types required for the various hull types are as follows:
Hull material
Glass reinforced plastic (GRP)
Steel
Aluminium
Wood
Other transducer types are also available for specific requirements. For
further details, contact your local Raymarine dealer.
For accurate speed readings the transducer should be sited within the
clear water flow areas indicated by the shaded areas in the following
diagram.
The transducer should also:
• Be ahead of the propellers (by a minimum of 10% of the water line
• Be at least 150 mm (6 in) away from the keel (ideally ahead of the
• Be as near as possible to the centre line of the vessel.
Transducer siting
length ).
keel if a sailing yacht).
ST60 Speed Instrument Owner's Handbook
Transducer type
M78712 Through hull plastic
M78712 Through hull plastic
M78712 Through hull plastic
M78716 Through hull bronze
Sailing vessel
Planing power
vessel
Displacement power
vessel
D4349-1