Remington HC9700 Manual page 6

ENGLISH
, TO ATTACH AND REMOVE A COMB
• Make sure the blade is locked into place.
• Install the desired comb attachment on the blade, it will latch into place.
• To remove, pull the removal tab first to release the latch and pull away.
, INSTRUCTIONS FOR CUTTING HAIR
• For even cutting, allow the comb attachment/blade to cut its way through the
hair. Do not force it through quickly. If you are cutting for the first time, start
with the maximum comb attachment.
, STEP 1 – Nape of the neck
• Attach the 3mm or 6mm guide comb.
• Hold the clipper with the blade teeth pointing upwards. Begin starting at the
centre of the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair,
trimming just a little at a time.
, STEP 2 – Back of the head
• With the 12mm or 18mm guide comb on the clipper, cut the hair at the back
of the head.
, STEP 3 – Side of the head
• With the 3mm or 6mm guide comb on the clipper, trim sideburns.
• Then change to the longer 9mm guide comb and continue to cut the top of
the head.
, STEP 4 – Top of the head
• Use the longer length guide comb 22mm or 25mm on the clipper to cut hair
on top of the head against the direction in which the hair normally grows.
• Always work from the back of the head.
6
Setting
1
2
3
4
5
Cut length
1.0
1.15
1.3
1.45
1.6