Table of contents Short instructions ... 14 Important notes ... 16 Precautions ... 16 Traffic safety ... 16 Installation/Connection ... 16 Anti-theft protection ... 16 Entry of a wrong code number ... 16 Switching on security coding ... 17 Re-start following an interruption of the power supply ...
Short instructions 1 On / Off: Turn the knob. To adjust the volume: Turn the knob. 2 TONE – audio To adjust the BASS TREBLE (treble control) To alter a setting: Toggle the TONE button until the corre- sponding abbreviation and the adjusted value appear in the display.
Page 5
Extra function: To switch between stereo and mono: Hold down the button for approximately 2 seconds. With stereo playback, the stereo sign “ ” will appear in the dis- play. : TS – Travelstore To store and recall the six most power- ful stations of the respective reception area automatically.
Do not ground the loudspeaker outputs! Use only the accessory and replacement parts approved by Blaupunkt. Anti-theft protection This car radio is supplied with inactive code protection. In order to switch the security coding system on, proceed as described in the following.
Turn on the radio. The display shows “CODE”. • Enter the code number given in the Blaupunkt car radio passport and con- firm (see example under “Switching on security coding”). The unit is now ready for use. Switching off security coding •...
Radio operation with RDS (Radio Data System) The Radio Data System offers you more convenience when listening to FM radio sta- tions. More and more radio stations have begun to broadcast RDS information alongside their programmes. As soon as a programme has been identified, the station name including a regional identi- fier, if applicable, will appear in the display, for example, NDR1 NDS (regional program-...
When holding the button down, the frequency scan is speeded up. Selecting the seek tuning sensi- tivity You can alter the automatic seek tuning sensitivity. For this, • press the lo·m button briefly. If “lo” is displayed, the radio will only pick up strong, local stations (low sensitivity).
Recalling stored stations You can recall any stored station at the touch of a button. • Select the memory bank by toggling the FM button until the desired level ap- pears in the display. • Press the corresponding preset button until the display shows the desired pre- set button.
Automatic seek tuning start Prerequisite: The priority for traffic announcements has been activated. When leaving the reception area of the tuned in traffic programme station while listening to a tape or after having turned down the vol- ume completely, the system will automati- cally start searching for a new TA program- If no such station is found within approxi- mately 30 seconds, tape operation will be...
Specifications Amplifier Output power: 2 x 10 W RMS power acc. to DIN 45324/3.1 into 2 Ω FM waveband Sensitivity: 1.3 µV at 26 dB signal-to-noise ratio Frequency response: 35 - 15 000 Hz Tape player Frequency response: 30 - 14 000 Hz Subject to modifications!