Table of Contents
Advertisement
Perform the following inspections before each use to ensure the surface cleaner is working properly.
•
Check for any worn or damaged parts. Replace any damaged part before using the surface
cleaner.
•
Check that all parts are tightly fastened. Tighten any that are loose.
•
Check that the casters swivel and the wheels roll smoothly. Repair or replace any that do not
function properly.
•
Check that all swivel and sprayer arms rotate smoothly.
•
Use a low-pressure water connection to check that the sprayer nozzles are clear and spray
correctly. If any nozzle does not, replace or clean the non-working nozzle (see maintenance
section).
•
Wear the proper personal protective equipment, including ANSI Z87.1 compliant eye protection.
•
Do not exceed the rated maximum pressure of 5000 PSI.
•
Keep hands, feet, and other body parts clear of nozzle heads and away from skirt while operating
the surface cleaner.
•
Use only on a hard, level surface.
•
No alterations shall be made to this product. Only attachments and/or adapters supplied by the
manufacturer shall be used.
•
Not for use by or around children.
1. After you've completed the Before Use inspections, place the surface cleaner at the edge of the
surface to clean.
2. Bring a pressure washer into the area.
3. Connect the surface cleaner wand to the pressure washer hose.
4. With one hand on the surface cleaner handle, start the pressure washer.
5. Slowly walk behind the surface cleaner watching for good cleaning action. Use the lance for hard-
to-reach areas.
•
Turn off the pressure washer and release pressure before converting between the wand and lance
connections to the washer to avoid injury from the high-pressure fluid.
6. When cleaning is complete, stop the pressure washer. When fluid pressure is released through
the sprayer nozzles, disconnect from the surface cleaner.
Before Each Use
Operating Instructions
⚠WARNING
⚠WARNING
Page 9 of 16
Advertisement
Table of Contents
