After Each Use; Maintenance; Replacing The Hose; Replacing A Nozzle - North Star 63594 Owner's Manual

Perform the following inspections after each use to clean the surface cleaner and prepare it for the
next use.
•
Clean out any dirt or foreign material from under the housing, wheels, and casters. If necessary,
use a cloth or sponge to wash the surface cleaner and rinse it with tap water.
•
Check for loose parts and any damage.
•
Disconnect the surface cleaner from a pressure washer and ensure that the surface cleaner is not
pressurized before performing any inspections, maintenance, or adjustments to avoid any wildly
spraying fluid that may cause personal injury and property damage.
Maintain the surface cleaner by adopting a program of conscientious repair and maintenance in
accordance with the following recommended procedures. It is recommended that the general
condition of any tool be examined before it is used. Keep handles dry, clean, and free from oil and
grease.

Replacing the Hose

Disconnect the bottom of the hose from the swivel piping and the top from the wand (as shown
below). Reconnect a new hose to these connections.

Replacing a Nozzle

To replace a clogged, worn, or damaged nozzle, simply unscrew it from the spray arm and screw on a
new or cleaned replacement nozzle. Plugged nozzles can easily be cleaned with a needle or small
paper clip.

After Each Use

Maintenance

⚠WARNING
Hose-Swivel Connection
Page 10 of 16