Cisco SM-X-NIM-ADPTR Connecting page 7

Connecting the Cisco Network Interface Module Adapter for SM-X Slot on the Cisco 4000 Seris Integrated Services
Installing the SM-X-NIM-ADPTR into a Cisco 4000 Series ISR
To install the SM-X-NIM-ADPTR into a Cisco 4000 Series ISR, see the following figure and the
procedure that follows:
Figure 2 Installing the SM-X-NIM-ADPTR into an ISR
2
1
1 NIM
2 SM-X-NIM-ADPTR
3 SM slot
Procedure
Step 1 Read the
Step 2 Remove the blank faceplate installed over the SM slot of the ISR.
Step 3 Remove the blank faceplate installed over the left slot of the SM-X-NIM-ADPTR.
Insert a single-wide NIM into the left slot of the SM-X-NIM-ADPTR. (See
Step 4
Push the SM-X-NIM-ADPTR into place until you feel the edge connector seat securely into the
Step 5
connector on the router backplane. The module faceplate should contact the chassis rear panel.
Using a number 1 Phillips or flat-blade screwdriver, tighten the captive mounting screws on the module
Step 6
faceplate.
Step 7 Check LEDs and confirm proper operation.
Note
Note
Connecting the Cisco Network Interface Module Adapter for SM-X Slot on Cisco 4300 and 4400 Series Integrated Services Routers
3
"Safety Warnings" section on page 4
A solid green LED indicates that the SM-X-NIM-ADPTR is correctly inserted. See
With the FXS NIM, Service-Engine (x/x/x) interface is created. Do not use the crypto map
(name) CLI on the Service-Engine (x/x/x) interface module.
before you perform any module replacement.
Figure 2.)
LED, page 2.
7