Cisco SM-X-NIM-ADPTR Connecting page 5

Connecting the Cisco Network Interface Module Adapter for SM-X Slot on the Cisco 4000 Seris Integrated Services
Read the installation instructions before connecting the system to the power source. Statement 1004
Warning
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry
tub, in a wet basement, or near a swimming pool. Statement 1035
Warning Never install telephone jacks in wet locations unless the jack is specifically designed for
wet locations. Statement 1036
Never touch uninsulated telephone wires or terminals unless the telephone line has been
Warning
disconnected at the network interface. Statement 1037
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
Warning
risk of electric shock from lightning. Statement 1038
To report a gas leak, do not use a telephone in the vicinity of the leak. Statement 1039
Warning
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
The following warnings apply in Australia:
Warning Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can
cause serious burns or weld the metal object to the terminals. Statement 43
Connecting the Cisco Network Interface Module Adapter for SM-X Slot on Cisco 4300 and 4400 Series Integrated Services Routers
5