Download Print this page

Broan 502 Instructions

Side discharge fans

Advertisement

Quick Links

MODELS 502 & 503 SIDE
DISCHARGE FANS
READ AND SAVE
THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS, OBSERVE THE FOLLOW-
ING:
1. Use this unit only in the manner intended by the
manufacturer. If you have questions, contact
the manufacturer at the address or telephone
number listed in the warranty.
2. Before servicing or cleaning unit, switch power
off at service panel and lock the service discon-
necting means to prevent power from being
switched on accidentally. When the service dis-
connecting means cannot be locked, securely
fasten a prominent warning device, such as a
tag, to the service panel.
3. Installation work and electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards, including fire-rated con-
struction codes and standards.
4. Sufficient air is needed for proper combustion and exhausting of gases through
the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the
heating equipment manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE),
and the local code authorities.
5. When cutting or drilling into wall or ceiling, do not damage electrical wiring and
other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. If this unit is to be installed over a tub or shower, it must be marked as appropri-
ate for the application.
8. Never place a switch where it can be reached from a tub or a shower.
9. This unit must be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1. Never leave surface units unattended at high settings. Boilovers cause smoking
and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
2. Always turn hood ON when cooking at high heat or when cooking flaming foods.
3. Clean ventilating fans frequently. Grease should not be allowed to accumulate
on fan or filter.
4. Use proper pan size. Always use cookware appropriate for the size of the
surface element.
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP
GREASE FIRE, OBSERVE THE FOLLOWING:*
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn
off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out
immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN - You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels - a violent steam
explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher and you already know how to
operate it.
B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
*Based on "Kitchen Firesafety Tips" published by NFPA.
CAUTION
1. For general ventilating use only. Do not use to exhaust hazardous or explosive
materials and vapors.
2. To avoid motor bearing damage and noisy and/or unbalanced impellers, keep
drywall spray, construction dust, etc. off power unit.
3. Please read specification label on product for further information and require-
ments.

TOOLS AND MATERIALS REQUIRED

Straight blade screwdriver
Phillips screwdriver
Hammer
Pliers
Electrical wiring and supplies of type to comply with local code
Nails or wood screws
3 1/4" x 10" duct, transitions and elbows, if required
Duct tape
Roof or wall cap
INSTALLER: Leave This Manual With The Homeowner. HOMEOWNER: Use and Care Information on Page 3.
INSTALADOR: Deje este manual con el dueño de la casa. DUEÑO DE LA CASA: Información del uso y cuidado en la página 3.
To register this product visit
www.broan.com
4. Se requiere una cantidad de aire suficiente para la combustión y expulsión de
5. Cuando corte o taladre en una pared o techo, no dañe el alambrado eléctrico otras
6. Los ventiladores conductos deben siempre extraer hacia el exterior.
7. Si esta unidad va a ser instalada encima de un baño o ducha, Tiene que tener
8. Nunca coloque un interruptor donde pueda ser alcanzado desde un baño o ducha.
9. Esta unidad debe ser conectada a tierra.
PARA REDUCIR EL RIESGO DE INCENDIO DEBIDO A GRASA ACUMULADA EN LAS
HORNILLAS:
1. Nunca deje sin atender las unidades de superficie cuando tengan ajustes altos.
2. Siempre ENCIENDA la campana cuando cocine con alta temperatura o cuando
3. Limpie con frecuencia los ventiladores. No debe permitir que la grasa se acumule
4. Utilice un sartén de tamaño adecuado. Siempre utilice el utensilio adecuado al
PARA REDUCIR EL RIESGO DE LESION A PERSONAS RESULTADO DE UN INCENDIO
DEBIDO A GRASA ACUMULADA EN LAS HORNILLAS, PROCURE LO SIGUIENTE:*
1. AHOGUE LAS LLAMAS con una tapa ajustada o charola de metal, después apague
2. NO LEVANTE NUNCA UNA SARTEN QUE ESTE EN LLAMAS - Usted se podrá
3. NO UTILICE AGUA, incluyendo toallas de cocina mojadas - puede resultar una
4. Utilice un extinguidor SOLAMENTE si:
* Basado en las recomendaciones para "Seguridad en la Cocina" publicadas por la
PRECAUCION
1. Solamente para uso de ventilación general. No se use para extraer materiales ni
2. Para evitar daños al cojinete del motor y/o impulsores ruidosos o desequilibrados,
3. Lea la etiqueta de especificaciones del producto para más información y requisitos.
HERRAMIENTAS Y MATERIALES NECESARIOS
Herramientas eléctricas del tipo
necesario para cumplir con los
códigos locales.
MODELOS 502 y 503
VENTILADORES DE
DESCARGA LATERAL
LEA Y CONSERVE
ESTAS INSTRUCCIONES
ADVERTENCIA
PARA REDUCIR EL RIESGO DE INCENDIO, DESCARGA
ELECTRICA O LESIONES PERSONALES, CUMPLA CON LOS
SIGUIENTES PUNTOS:
1. Solamente use esta unidad de la manera propuesta por el
fabricante. Si tiene alguna pregunta, póngase en contacto con
el fabricante en la dirección o teléfono anotados en la garantía.
2. Antes de limpiar o de poner en servicio la unidad, apague el
interruptor en el panel de servicio, y asegure el panel de
servicio para evitar que se encienda accidentalmente. Cuando
el dispositivo para desconectar el servicio eléctrico no puede
ser cerrado con algún tipo de traba, sujete fuertemente al panel
de servicio, una etiqueta de advertencia prominente.
3. El trabajo de instalación y el alambrado eléctrico deben de
llevarse a cabo por personal competente de acuerdo con todos
los códigos y las normas correspondientes, incluyendo los
códigos y normas de construcción contra incendios.
gases por la chimenea en el equipo de quemado de combustible para evitar la
retrogresión de la llama. Siga las especificaciones del fabricante del equipo de
calefacción y las normas de seguridad semejantes a las publicadas por la Asociación
nacional de protección contra incendios (NFPA por sus siglas en inglés), y la
Sociedad americana de ingenieros de calefacción, refrigeración y aire acondicionado
(ASHRAE), y los códigos de las autoridades locales.
instalaciones ocultas.
impreso que es adecuada para ese uso.
Los reboses pueden provocar humo y derrames grasosos que se pueden
incendiar. Caliente lentamente el aceite en un ajuste bajo o medio.
cocine alimentos que se puedan incendiar.
en el ventilador ni en el filtro.
tamaño del elemento de superficie.
la hornilla. TENGA CUIDADO A FIN DE EVITAR QUEMADURAS. Si las llamas no se
apagan de inmediato, EVACUE Y AVISE A LOS BOMBEROS.
quemar.
explosión de vapor violenta.
A. Usted sabe que tiene un extinguidor de clas ABC y lo sabe utilizar.
B. El incendio es pequeño y contenido dentro del área donde se inició.
C. Los bomberos han sido avisados.
D. Usted puede combatir el incendio con una salida a su espalda.
NFPA de los EEUU.
vapores peligrosos o explosivos.
mantenga la fuente de potencia lejos de rocíos de pared seca, de polvo de
construcción, etc.
Destornillador de hoja
Destornillador de Phillips
Martillo
Alicates
Clavos o tornillos para madera
Conducto redondo de 8,25 x 25,40 cm
(3–1/4" x 10 plg.), transiciones y codos,
si es necesario
Cinta adhesiva para conductos
Cubierta de techo o pared

Advertisement

loading

Summary of Contents for Broan 502

  • Page 1: Tools And Materials Required

    MODELOS 502 y 503 MODELS 502 & 503 SIDE VENTILADORES DE DISCHARGE FANS DESCARGA LATERAL LEA Y CONSERVE READ AND SAVE ESTAS INSTRUCCIONES THESE INSTRUCTIONS ADVERTENCIA WARNING PARA REDUCIR EL RIESGO DE INCENDIO, DESCARGA ELECTRICA O LESIONES PERSONALES, CUMPLA CON LOS...
  • Page 2: Typical Installations

    TYPICAL INSTALACIONES TIPICAS FIG. 1 TO ROOF INSTALLATIONS Veánse las figuras 1 a 4 para ver ejemplos de instalaciones A LA típicas. CUBIERTA Please see figures 1 through 4 for examples of typical PREPARACION installation. TECHO DEL VENTILADOR PREPARE FAN 1.
  • Page 3 OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WAR- PROPOSITO PARTICULAR. RANTIES OF MERCHANTABILITY OR FITNESS FOR A PAR- Durante el período de un año, y a su propio criterio, Broan-NuTone TICULAR PURPOSE. reparará o reemplazará, sin costo alguno, cualquier producto o pieza...
  • Page 4: Service Parts

    ** Not Illustrated. ** No ilustrad Order service parts by "Part No." - NOT by "Key No." Encague piézas de servicio per "No. Piez" - NO "por No. Codigo" Broan-NuTone LLC • 926 W. State Street • Hartford, WI 53027 99042341H...

This manual is also suitable for:

503