Control Panel Menu Structure; Select The Starting Dmx Address; Select The Channel Mode; Master/Slave Mode - Blizzard POCKET PULSAR User Manual

Control Panel Menu Structure

AuTo
Soud
d001
SLAu
chSE
SPEd
SEnS
DMX Mode
Allows the unit to be controlled by any universal DMX controller.

Select the Starting DMX Address

1.) Navigate the main menu to reach d---, press <ENTER>.
2.) Use the <UP/DOWN> buttons to choose a starting DMX address
ranging from d001-d512, press <ENTER> to confirm, or <MENU> to exit.

Select the Channel Mode

1.) Navigate the main menu to reach chSE, press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight CH07 or CH09, press the
<ENTER> button to confirm.

Master/Slave Mode

1.) Daisy chain fixtures together via DMX input/output connections.
2.) On all fixtures to be designated slave units, navigate to highlight SLAu,
press <ENTER>.
3.) The first fixture in the DMX chain is the master fixture, and the
following units will operate in unison with the master.
Auto and Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs.

Auto Mode

1.) Navigate the main menu to reach AuTo, press <ENTER>.
2.) The fixture will now run in auto mode.
3.) To adjust the speed, navigate the menu to SPEd, and press <ENTER>.
4.) Highlight a speed level ranging from s01 to s64, and press <ENTER>.

Sound Active Mode

1.) Navigate the main menu to reach Soud, press <ENTER>.
2.) The fixture will now run in sound active mode.
3.) For mic sensitivity, navigate the menu to SEnS, and press <ENTER>.
4.) Highlight a level ranging from 0% to 100%, and press <ENTER>.
Pocket Pulsar™ Manual Rev. A
<ENTER>
<ENTER>
d001-d512
<ENTER>
CH07-CH09
s01-S64
000-100
Auto mode
Sound active mode
Select a starting DMX address: 001-512

Slave mode

To select DMX channel mode 7 or 9
Speed setting 01-64 (slow <-> fast)
Mic sensitivity (0% <-> 100%)
Page 11
© 2019 Blizzard Lighting, LLC