Usb Interface; Using The Zr 7 Remote Control - NAD T 778 Owner's Manual

USB INTERFACE

The HTR 8 allows one to upload and download the configuration through
a Windows PC and NAD's Proprietary HTR 8 programming software. Use
®
a USB A male to mini USB B male 5-pin cable (not supplied) between your
Windows PC and the HTR 8. See illustration below on how to connect a
®
USB A male to mini USB B male 5-pin cable to the HTR 8.
NOTE
Please log onto www.nadelectronics.com/HTR8 for the latest HTR 8
interface control software. Your custom installer or dealer can assist
you in the proper setup and configuration of the mini USB interface and
software.
SLEEP MODE
The Sleep Mode timer will switch the T 778 to Standby mode automatically
after a preset number of minutes. Pressing the HTR 8's SLEEP button once
will display the setting of the sleep time increment. Pressing the HTR 8's
SLEEP button a second time within a 3-second period will change the
sleep time increment in 15-minute intervals, after which time the T 778 will
automatically switch into Standby mode.
To adjust the sleep delay, press the HTR 8's SLEEP button twice; first to
display the sleep time increment, and a second time to change the
sleep time increment. The sleep time increment and a "SLEEP" icon will
continuously display on the T 778's front panel Vacuum Fluorescent Display
(VFD). Each consecutive press increases the sleep time in 15-minute
increments from 15 to 90 minutes. To cancel the sleep mode, continue
pressing the HTR 8's SLEEP button until "Sleep Off" displays on the VFD.
Switching the T 778 to standby from either the HTR 8's OFF or the T 778's
STANDBY button will also cancel the sleep mode
USING THE HTR 8 REMOTE CONTROL

USING THE ZR 7 REMOTE CONTROL

The ZR 7 is a discrete compact remote for controlling the Zone 2 feature of the
T 778. Irrespective of the main room/zone settings, the ZR 7 allows full separate
control of the Zone 2 source selection among other applicable features.
1 ON/OFF: Switch ON/OFF the Zone feature.
2 SOURCE [ d/f ]: Select the active input of the NAD T 778 that will be
sent out to the corresponding rear panel ZONE 2 output port.
3 MUTE: Temporarily switch OFF or restore the Zone Volume level.
4 VOLUME [ d/f ]: Increase or decrease the loudness level of selected
Zone source. This is possible only if the VOLUME setting of ZONE 2
CONTROLS is set to VARIABLE.
5 PRESET [ a/s ]: Step up or down between stored radio presets. This
control button is possible if the selected Zone is "TUNER" and the active
tuner section has stored presets. This control button is not applicable to
T 778.
6 The following CD Player Zone buttons can control a compatible CD
Player. The CD Player has to be powered ON and disc loaded.
SKIP [ 0 ]: Go to the next track/file.
SKIP [ 9 ]: Go to the beginning of a track/file or previous track/file.
[ 4 ]: Start playback.
NOTE
The ZR 7 remote control will only control Zone 2 applications. Zone 3
and Zone 4 could be configured and managed at the appropriate
Zone OSD menu using the front panel navigations keys as well as the
corresponding keys on the HTR 8 remote control. The HTR 8's 'CUSTOM'
device is also defaulted to Zone 2 remote control codes.
OPERATION
33