Pitney Bowes 397-C Installation Manual

397-C , 397-D
(30 lb)
Installing your scale
Connect Scale
1
Note: Set the scale on firm, flat surface.
Using your scale
Operating Temperature Range 59F to 86F (15C-30C).
Operating outside this range may require calibration.
To power on the scale
The scale is powered on when your computer is
running.
If you are not using USB, press the power button
on the front of the scale to turn the scale on and
off.
When the scale is first turned on, wait a few seconds for the
scale to stabilize before weighing items.
The display shows 88.8.8.8.8 for a few seconds and then 0.0
when ready. A will be displayed on
the left side of the display when the weight is stable.
To weigh an item
Place an item on the
scale platform.
If using large envelopes,
lift the top of the scale
platform to a 90-degree
position and place the
envelope in an upright
position on the platform.
A will appear on the left side of the display
when the weight is stable.
Scale Installation Guide
(70 lb)
2
- If not using the USB to power the scale, you may use a 9-volt
battery (not included).
- Open battery compartment cover, attach a 9-volt Alkaline battery
and close campartment.
NOTE: Make sure to attach the battery correctly. Attaching the battery
backwards can damage the scale and cause smoke or burning.
Changing the units of measure
Your scale can display weight in English (pounds)
or metric (kilograms) units. The default unit of
measure is English.
Press the Mode button to toggle between English
and Metric units.
Using the Hold button
When an item being weighed extends over the
front of the scale and you cannot see the display,
you can freeze the display so that the weight is still
displayed after removing the item.
1 - Place the item on the scale.
2 - After a few seconds, press the Hold button and
remove the item from the scale.
The weight continues to be displayed for several
seconds.
9v 9v
1/2