Table of Contents
Advertisement
Troubleshooting
Problem
No image or wrong image on TV3
Interference in the image on TV3
The video sources do not respond • Point the remote control directly to the receiver (A).
to the remote control commands
from TV3
The image of the video source
disappears on TV3
Tip
• Make sure SCART cables are firmly inserted.
• Make sure the receiver (A) is connected to TV3.
• Make sure both receiver (A) and transmitter are switched on.
• Make sure the video source is switched on.
• Make sure the correct SCART input on TV3 is selected.
• Select the correct video source with +/- on the receiver (A).
> Only for the SLV5400 transmitter.
• f the video source gives proper image on TV1:
Make sure the video source gives video signal in CVBS mode.
> See its user manual
• Change the wireless channel that is used for communication.
> See the user manual (E) page 6.
• The receiver (A) is out of range of the transmitter.
The number of walls and ceilings in between the receiver (A) and
transmitter restrict the distance.
• Slightly change the position of the receiver (A) or the transmitter.
• Change the wireless channel that is used for communication.
> See the user manual (E) page 6.
• The receiver (A) is out of range of the transmitter.
The number of walls and ceilings in between the receiver (A) and
transmitter restrict the distance.
• Replace the batteries of the remote controls with new ones.
• Install the remote control blaster cord.
> See the user manual of the Wireless TV Link.
• The maximum operating distance of the remote control is 5 m.
• Turn off the auto standby mode of the video source.
> See its user manual.
• Follow the instructions to reconnect the videosources.
> See the quick start guide of the Wireless TV Link.
Advertisement
Table of Contents
