H3C S9500E Series Connecting Manual page 12

NOTE:
SFP+ cables are hot swappable.
•
When connecting an SFP+ cable, make sure the bend radius of the cable is no less than eight times of
•
the diameter of the cable.
Figure 11 SFP+ cable
(1) Connector
To connect an SFP+ cable:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
1.
grounded.
Unpack the SFP+ cable.
2.
Insert one end of the plug of the SFP+ cable horizontally into the SFP+ slot on the switch and the
3.
other end of the plug into the SFP+ slot of the peer device.
Installing fiber management tray (optional)
NOTE:
The installation method described below is based on an N68 rack. The installation procedure is only for
your reference if you use a non-N68 rack.
A fiber management tray (FMT) is installed in a rack for winding redundant fibers between the S9500E
switches and other devices.
Preparations
1.
Confirm the following prerequisites:
The rack is fixed.
The switch is installed.
The installation involves the following materials:
FMT
M5×10 self-tapping screws (two screws for one FMT)
Installation procedure
2.
To install the fiber management tray, follow these steps, as shown in
Align the FMT and the installation holes on the column of the rack.
a.
Use a Phillips screwdriver to fix each FMT with two M5×10 self-tapping screws.
b.
(2) Pull latch
11
Figure 12.