Full Upgrade - Samsung ST80 Service Manual

4-3 Full upgrade

♦ How to execute the FULL firmware
The firmware is configured in the following structure.
Code area is where the execution codes to operate the camera are located, and the Partition [1:3] area is where the various resources neces
sary to operate the camera are saved. Among these areas, Partition 3 area is where the Defective Pixel adjustment data and Lens Shading
adjustment data are saved.
User Area is where the setting values are saved through the menu when the user uses the camera, and the adjusted data through integrated
process is saved.
code
► Reference of FULL version:
- This is the version that can update the section of Code + Partition[1:3]. The adjustment data that saved at user area is preserved but
the adjustment data for Defective pixel and Lens shading can be reset. When you do the Full version upgrade, the adjustment data will be
back up and when the upgrade is done, camera will turn off automatically after recovering the data.
1. Insert the SD card containing the FULL FW data file and Upgrade Script file into the camera.
* You need two files for FULL FW upgrade and the required files are FULL FW data file and Upgrade Script file.
* Because all data saved on the FLASH memory will be reset when you upgrade the firmware, back up your data before proceeding with the
upgrade.
2. Use the AC adaptor or fully charged batteries for the power.
- You can proceed with the upgrade only when the battery level is full (Icon showing full up to 3rd level).
3. Turn on the power of the camera.
SAMSUNG
partition1
This Document can not be used without Samsung's authorization
<Table 4-2>
partition2
Power ON
Fig. 4-6
partition3 User Area
Firmware update
4-3