Table of Contents
Advertisement
TEMPERATURE screen
Sections only
shown if
recirculation is
installed
A TANK MATERIAL button/indicator
This button/indicator shows the temperature setting of the material in the "A" material tank temperature in
C°. The A TANK MATERIAL indicator will show the current tank temperature setting.
To change the "A" material oven temperature, do the following:
1.
Select A TANK MATERIAL button, a numeric keypad should appear.
2.
Enter in the material set point temperature required.
NOTE: This temperature must be within the set point range.
3.
Press the ENTER button.
4.
The new material temperature should appear in the A TANK MATERIAL indicator.
Optional A Recirc Hose button/indicator
This button/indicator shows the set point of the material in the "A" component recirculation hose in C°.
The recirculation indicator will show the current material temperature setting.
To change the "A" component recirculation material temperature, do the following:
1.
Select A recirculation button, a numeric keypad should appear.
2.
Enter in the material set point temperature required.
NOTE: This temperature must be within the set point range.
3.
Press the ENTER button.
4.
The new material temperature should appear in the A recirculation indicator.
A DISP. HOSE button/indicator
This button/indicator shows the set point of the material in the "A" component dispense hose in C°. "A"
component dispense hose temperature indicator will show the current dispense hose material temperature
setting.
To change the "A" component dispense hose temperature, do the following:
1.
Select A DISP. HOSE button, a numeric keypad should appear.
2.
Enter in the material set point temperature required.
NOTE: This temperature must be within the set point range.
3.
Press the ENTER button.
14
Advertisement
Table of Contents
