HELIX V EIGHT DSP MK2 Manual page 31

tivated it is mandatory to use the remote input
terminal to power up the amplifier! The highlev-
el signal will be ignored in this case.
Note: The automatic turn-on feature of the
highlevel inputs is activated ex works.
To deactivate the automatic turn-on feature
you have to open the device and change the
position of the "Auto Remote" switch. There-
fore the device has to be opened as described
in item 4.1. The switch is located near by the
"Made in Germany" imprint (see marking in the
following picture).
On: Activation via highlevel speaker input is
enabled (ex works).
Off: Activation via highlevel speaker input is
disabled.
8. Configuration of the internal DSP
The general DSP settings should be con-
ducted with the DSP PC-Tool software be-
fore using the amplifier for the first time.
Ignoring this advice may result in damaging the
connected amplifiers / loudspeakers. Informa-
tion about connecting the V EIGHT DSP MK2
to a computer can be found on page 33.
9. Connecting the loudspeaker outputs
The loudspeaker outputs can be connected di-
rectly to the wires of the loudspeakers. Never
connect any of the loudspeaker cables with the
chassis ground as this will damage your ampli-
fier and your speakers.
Ensure that the loudspeakers are correctly con-
nected (in phase), i.e. plus to plus and minus
to minus. Exchanging plus and minus causes a
total loss of bass reproduction. The plus pole is
indicated on most speakers. The impedance of
the speakers must not be lower than 2 Ohms.
10. Connecting the remote output
This output (Rem Out) is used to supply remote
signals to the external amplifier/s. Always use
this remote output signal to turn on the ampli-
fiers in order to avoid on / off switching noises.
31