Problem Solving - Philips DMVC300K/00 Instructions For Use Manual

Philips webcam dmvc300k
Table of Contents

Advertisement

7. Problem solving

Problem
No photo is taken
while the Shutter • Recharge battery. See 'Recharging the battery.
button is pressed
all the way down
No reaction
to controls
File transfer not
possible
Not all images
can be transferred
to the PC
Camera
connected to PC
but the Philips FunCam
driver says:
'Device not ready'.
If a fault occurs, first check the points listed below. If you are unable to
remedy a problem by following these hints, contact the helpline
(see 'Helpline') or consult your dealer.
Never try to open the camera yourself as this will void the guarantee.
First, check all cables to ensure that they are connected correctly.
Possible cause / Solution
Battery exhausted
Memory full
• Transfer photos/video recordings to your PC or clear photos in order to
create memory space. See 'Transferring/viewing photos and video
recordings' and/or 'Clearing photos and video recordings'.
Camera is still connected to the PC's USB port
• Disconnect the camera from the PC's USB port or take the camera out
of its desktop stand.
Poor light conditions
• Try to improve light conditions.
Camera turned off automatically (no button pressed for 60 seconds)
• Turn the camera back on. See 'Turning the camera on and off '.
Battery exhausted
• Recharge battery. See 'Recharging the battery.
USB cable not properly connected
• Properly connect USB cable to both desktop stand and PC and make
sure the camera is placed on the desktop stand.
USB driver not installed
• Install USB driver and 'Philips Photo Manager' on your PC.
The RAM memory installed in your computer may not have
sufficient storage space.
• Close all software programs and proceed to transfer your images. If the
problem persists, transfer images in batches and store each batch on
your hard drive before proceeding to the next batch. Make sure all the
images you want are stored before you clear the camera memory.
• Check if the camera power is turned on. If not, turn it on and then
connect the camera to the PC again by placing it on the desktop stand.
ENGLISH
29

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dmvc300/00Dmvc300kDmvc300Dmvc300k/37Funcam dmvc 300k

Table of Contents