Table of Contents
Advertisement
14.0 Adjustments:
14.1 Adjustment of the footrest (Fig. 14.1.1 & 14.1.2):
To adjust the height of a footrest:
Depending on footrest type, loosen the screw using either a
4mm allen wrench or an 11mm socket and set the footrest at
the height desired, then tighten the screw in the hole.
Note: Make sure that the screws are tightened securely.
14.2 Inner Or Outer Width Adjustment of the footrests:
Using an optional kit the width between the footrests can
be made 4cm larger or smaller than standard. An instruction
sheet is included in the kit.
56
Q100R-Q200R Configured Rev. A
14.3 Adjustment of the armrests:
Height adjustment (Fig. 14.3):
Loosen cap screw (arrowed), lift armpad to desired height,
tighten cap screw to a torque of 3-7Nm.
14.4 Seat width adjustment (Fig. 14.4):
Fig. 14.1.1
To adjust the width between the armrests, use a size 5mm
allen wrench to loosen the cap screws on the armrest adapter
retainers, which are located on the side frame below the
armrests, and pull the armrests outwards or inwards to achieve
the desired position. Tighten screws to a torque of 3-7Nm.
Fig. 14.1.2
14.5 Seat Centre of Gravity Adjustment:
The Q200R Configurable product has the added feature of Seat
forward/rearward adjustment. This can be used to adjust the
centre of gravity by moving the seat/user position relative to
the base. Centre of gravity adjustment maybe necessary to
both improve stability on slopes and tractions (driveability) for
certain types of users.
WARNING!
Adjustments to the centre of gravity must ONLY be carried
out by qualified Rehab engineers that have been trained
and approved. Therefore instructions of how to make such
adjustments are deliberately NOT included within this
manual so they are only available to those qualified. Incorrect
Fig. 14.2
adjustment may lead serious lack of product stability and a risk
of tipping or sliding which can result in serious injury.
Fig. 14.3
Fig. 14.4
Advertisement
Table of Contents
Troubleshooting
