Table of Contents
Advertisement
Installing the Device
2.5.2 Connecting External PoE Power
7.
8.
2.5.2
Connecting External PoE Power
The RUGGEDCOM RSG2100P supports up to four 10/100Base-TX Power-over-Ethernet
(POE) Ports that require power from an external source.
Note
For IEC 61850 compliance, use an IEC 61850 compliant PoE power supply with pow-
er cabling no longer than 3 m (118 in).
External Power Supply Requirements
To support the IEEE 802.3af specification (15 W/port output), the external power
supply must meet the following requirements:
16
Using a #6 ring lug and #6-32 screw, secure the ground terminal on the power
source to the chassis ground terminal on the device. Make sure the lug is tight-
ened to 1.7 N·m (15 lbf·in).
1
Stainless Steel Stud
1
#6-32 Screw
2
#6 Ring Lug
3
Figure 2.6
Chassis Ground Connection
DANGER
Electrocution hazard – risk of death, serious personal injury and/or damage
to the device
Make sure the supplied terminal block cover is always installed before the de-
vice is powered.
Install the terminal block cover.
Power Sup-
ply Type
Minimum
DC
45 VDC
2
3
Input Range
Maximum
57 VDC
Isolation
Minimum Pow-
er Required
1.5 kVAC/2.2 kVDC
RUGGEDCOM RSG2100P
Installation Manual, 01/2020, C79000-G8976-1041-16
75 W
Advertisement
Table of Contents
