Table of Contents
Advertisement
PRIMERGY S40-DF capacity extension Converting the PRIMERGY S40-DF
Mounting is performed in the reverse order. For mounting, the four metal tabs
(1) must first be inserted into the corresponding openings (2) (see figure 7).
Figure 7: Mounting the protective shield
1.4.4
Converting the internal configuration
V
CAUTION!
The actions described here should only be performed by technicians,
service personnel or technical specialists. Any failure to observe the
guidelines in this manual could expose the user to considerable risks
(electric shock, fire hazards) and could also damage the equipment.
Note that any unauthorized opening of the device will result in the
invalidation of the warranty and exclusion from all liability.
In order to install a capacity expansion with three PRIMERGY S40-ES units,
you will need to first change the internal cabling of the PRIMERGY S40-DF from
a 3-channel configuration (figure 8 on page 12) to a 1-channel configuration
(figure 12 on page 16).
The same method applies to all housing models.
U41100-J-Z156-1-74
11
Advertisement
Table of Contents
