Replacing The Heater Tube (Fru Kit No. 2045962-001); Figure 89: Rear View Of The Heater Assembly; Figure 90: Front View Of The Heater Assembly - GE Lullaby Warmer Maintenance And Service Manual

inserted into the hood.
2. Insert observation lamp cable and heater cable through the rear bracket and the hood
pillar. Fasten the retaining sleeve to the rear bracket. Please follow step 5 in reverse for
assembling the retaining sleeve.
3. Put back the front bracket and the front cover (Refer to 7.1.2 Front Bracket Replacing
Procedure).
4. Assemble the rear cover.
5. Mount the hood assembly on to the warmer.
6. Connect the free end of the following cables to the PWA:
a. Heater cables
b. Observation lamp cable
c.
Swivel sensor cable

7.1.10 Replacing the Heater Tube (FRU Kit No. 2045962-001)

Illustration
Plug Button
M5 PAN Head Screw

Figure 89: Rear view of the Heater Assembly

Figure 90: Front view of the Heater Assembly

82 2042376-001 Rev G ©2012 General Electric Company. All rights reserved. Lullaby
Nut, washer and spring for Reflector
Cap
Heater Assembly (Front Side)
Heater Tube
Reflector Cap
M3 Reflector Cap Screw
Neutral Wire
Ground Wire
Wire Clamps
Live Wire
Warmer
TM