IBM System Storage N Series Implementation Manual page 47

Booting the new
gateway with disks
for the first time
Chapter 3: Installing a New Gateway with Disks
To boot your system for the first time, complete the following steps.
Step Action
1 Check that the disk shelves are set up properly and that the switches
are terminated, where applicable.
2 First turn on the power to any switches, then to the disk shelves, and
then to any tape backup devices.
Attention
Make sure that the network and SAN switches are powered on and
configured before you turn on your gateway.
3 Turn on the power to the gateway.
Note
It takes the LEDs on the system power supplies a few seconds to
illuminate.
Result: The system begins to boot, and then stops at the first
installation setup script question, which is displayed on the system
console.
4 Verify that all network and RLM LEDs are properly illuminated.
5 Go to the system console and complete the setup script using the
information you gathered and entered in the worksheet from the
appropriate Data ONTAP Software Setup Guide.
Note
If you configured the RLM, the setup script pauses for a short time
while the RLM reboots and sets its configuration information.
6 Check the licenses on your system by entering the following
command:
license
33