Philips FC9178/01 User Manual page 20

Philips performer vacuum cleaner with bag fc9178/01 energycare parquetcare
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
English
20
Problem
The suction power is
insufficient.
2
Use a screwdriver to remove the screw of the battery compartment
lid (1) and remove the battery compartment lid (2).
3
Insert two new AAA 1.5-volt alkaline batteries into the handle.
Note: Make sure that the - and + poles point in the right direction.
4
Reattach the battery compartment lid (1) and fasten the screw with
a screwdriver (2).
guarantee & service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone number in the worldwide
guarantee leaflet). If there is no Consumer Care Centre in your country, go
to your local Philips dealer.
troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your country.
Possible cause
You have selected a low
suction power setting.
The motor protection filter is
dirty.
The HEPA 13 filter is dirty.
Solution
Select a higher suction power setting.
Clean the motor protection filter.
Clean or replace the HEPA 13 filter.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fc9178/03Fc9179Fc9178

Table of Contents