Preamp - Roland UA-S10 Manual

Preamp

Input Level Meter
This indicates the level of the input signal.
48V
MIC 1 SENS
HPF COMP
MIC 2 SENS
HPF COMP
LINE IN L SENS
LINE IN R
SENS
AUTO-SENS
1
Click [AUTO SENS].
2
Turn on the channel that you want to
use auto-sense.
3
Input sound.
4
When you have finished, click [FINISH].
If you decide to cancel, click [CANCEL].
2
4
LINK
If this is on, sensitivity and compressor settings will be linked in stereo.
This setting is on as the fixed value if the input is [LINE IN], and is off as the fixed value if the
input is [MIC 1/LINE R].
48V HPF
Phantom power can be Enables the low cut filter for
supplied to the MIC 1, 2 jacks. the input.
Turn this on if you're using a
Cutoff frequency: 75 Hz
device that requires phantom
power, such as a condenser
Down
mic.
sampling
This is not available for the
LINE IN jacks.
Φ (Polarity)
Inverts the polarity of the
input signal.
SENS
Adjusts the input signal's
sensitivity.
MIC 1, 2 jacks 0–58 dB
LINE IN jacks 0–32 dB
Changing the AUTO-SENS Settings
You can choose whether AUTO-SENS will be ended automatically or manually. You can
also specify the maximum setting for the recording level. The recording level will be set
automatically according to the maximum volume that was input during the AUTO-SENS
setting time.
Windows
From the "Options" menu, select [Device settings].
Mac
From the "UA-S10 Control Panel" menu, select [Device settings].
Value Explanation
AUTO The AUTO-SENS setting will finish automatically when there has been no
(default) input for approximately four seconds, after the [AUTO-SENS] was clicked.
MANUAL AUTO-SENS settings will not end until you click [FINISH] or [CANCEL].
Range for Margin: 0–12
Value Explanation
6 (default) Headroom is set at 6 dB. This setting provides a good overall balance.
The maximum value for the recording level is set at 0 dBFS. Clipping will
0
occur if audio that exceeds the recording level detected by AUTO-SENS is
input.
12 Headroom is set at 12 dB. The recording level will be reduced.
5
Input Settings