Chapter 2 Mounting This Product - Fujitsu PRIMERGY PG-RSBOP2 User Manual

Chapter 2 Mounting This Product

This chapter describes how to mount the remote service board and connect the cable for this
product on the PRIMERGY N800.
To use the Remote Service Board, mount the Remote Service Board , install ServerView
and connect the LAN/modem by the flow shown in the figure below.
Preparations
1.
→ "2.1 Preparations for Mounting This Product"
Mounting on Server Unit
2.
→ "2.2.1 PCI card and internal cable"
→ 2.2.1.1 Mounting on PRIMERGY N800
Connecting of AC Adapter
3.
→ "2.2.2 Connecting of AC adapter"
Setting Up System Resources
4.
→ "2.2.3 Setting up system resources"
Updating the Firmware
5.
→ "2.2.4 Updating the firmware"
Installing the Driver
6.
→ "3 Installing the Driver"
Connecting the LAN/Modem
7.
When using a LAN → "5.1 Connecting the LAN Cable"
When using a modem → "5.2 Connecting the Modem"
2