Renault Modus Manual page 200

EMERGENCY SPARE WHEEL
5
To wind a wheel back up
To carry out this operation, the
cable must be unwound.
If the cable has been wound back up
on its own, unwind it again as
follows:
- Pull the handle to unwind the
cable,
- press the button located under
handle 5 to hold the unwound
cable, then guide it down,
- recover the cable from underneath
the vehicle.
- attach the cable end piece to the
wheel support.
You may refit the wheel.
(continued)
After changing a wheel, position the
replaced wheel on support 9, with
the valve facing the
Depending on the
reposition shim 8. Clip cable 6 into
housing 7 then push the wheel
underneath the luggage compartment
(tab 10 towards the rear of the
vehicle).
Make sure that no one
has their fingers close to
the cable when you move
the handle: risk of injury
6
7
8
9
Position yourself behind the vehicle
ground.
and pull handle 5 to raise the wheel
vehicle,
until it is anchored under the
vehicle.
10
5.03