Husqvarna WS 442 Operator's Manual page 8

2. To attach the product, lift the lock handle against the
product until the handle locks.
3. Use the pin to lock the handle.
To assemble the blade
WARNING: Disconnect the product from the
power supply before you start the assembly.
1. Remove dirt from the contact surfaces on the blade
flange and blade.
2. Make sure that the blade rotates with the used part
of the diamond in the rotation direction of the blade.
Note: Because the blade rotation direction can be
selected, the water spray from the blade can also be
selected.
8
3. Assemble the outer blade flange, blade and blade
flange hub. Use tightening torque 70-80 Nm.
4. Hang the blade with the blade flange and blade
flange hub on the cutting arm.
5. Turn the blade flange hub carefully until it moves into
1 of the tracks in the pivot arm. Attach the blade
flange hub with the bolt.
1094 - 002 - 26.09.2019