Advertisement
Connecting the Cables
9 8
2
1
1 DC IN connector
2 Digital interface connector
3 Camera cable
4 Digital interface cable
5 Fastening screws
6 Serial cable
7 Monitor cable
8 Monitor output connector
9 RS-232C connector
Connect the camera cable to the DC IN connector and the digital
interface cable to the digital interface cable respectively. Also, if
needed, connect the monitor cable to the monitor output connector
and the serial cable to the RS-232C connector respectively. When
you connect the digital interface cable or monitor cable, turn the two
fastening screws on the connector to secure the cable tightly.
Connect the other end of the camera cable to the DC-700/700CE
and the other end of the digital interface cable to the camera module
interface board. Also, if needed, connect the other end of the monitor
cable to the monitor and the other end of the serial cable to the
camera control device.
About the Camera Control Method
You can control the camera from host device such as a PC.
The following table shows the control functions.
You can send a command corresponding to the control items, with
parameters for the desired settings, if necessary, from the host
device to control the camera.
Control functions
Operating mode
Normal
Shutter
Edge
speed
Trigger
Trigger pulse width
Gain
Binning function
Partial Scan function
Detail
External trigger input
White balance
Color Matrix
Note
Make sure to supply power to the camera module and confi rm that
the camera module is operating before inputting a trigger signal.
If you input external signals to a camera module without the power
supplied, this may cause a malfunction of the camera module.
7
6
4
5
3
Description
XCL-U1000
XCL-U1000C
Normal/Trigger
1 sec to 1/10000 sec
Internal setting: 1/15 sec to 1/10000 sec
Setting by trigger pulse width
0 dB to 18 dB
OFF/ON
−
OFF/ON
OFF/ON
26-pin connector / 12-pin connector
Preset
−
Manual
One push (auto)
−
OFF/ON
Trigger Pulse Input Specifi cations
DC IN terminal
(When positive pole is set)
100 μs to 1 sec
(When negative pole is set)
100 μs to 1 sec
• Input impedance: 10 kΩ or more
DIGITAL IF terminal
When operating a camera module by inputting an external trigger
signal via the 26-pin connector, be sure to input trigger signals that
satisfy the following specifi cations to both of the two terminals.
Trigger signal specifi cations (conditions)
Amplitude:
LVDS (output by the 3.3 volt IC)
Connection:
Input a TRIG (–) signal to the 9th pin
Input a TRIG (+) signal to the 22nd pin
Exposure Output Specifi cations
Exposure time
• When terminated at 10 kΩ or more
Exposure output is output as a pulse that indicates exposure time
when trigger mode is selected.
4.5 V to 5.0 V
0 V to 0.5 V
4.5 V to 5.0 V
0 V to 0.5 V
Polarity: positive
(DC IN terminal only)
4.0 V to 4.5 V
0 V to 0.5 V
XCL-U1000/U1000C
33
Advertisement
