Download Print this page

Invacare I-Fit 9780E User Manual page 2

Hide thumbs Also See for I-Fit 9780E:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Assembling the Shower Chair
Attaching the Legs
B
A
B
F
1.
Allow the shower chair adjust to room temperature, if
necessary.
Place the seat A upside down on a flat, stable surface (floor or
2.
table).
Position one leg B over one socket C in the seat and align.
3.
4.
Push the leg down into the socket until it is fully seated and
the locking tabs D are through the socket tab windows E.
Pull up on the leg to ensure that it has "locked" F into place.
5.
6.
Repeat STEPS 2-5 for the remaining three legs.
Adjusting Leg Extension Height
C
A
Ensure that the shower chair is level and stable before use.
To increase leg height:
Rotate the leg extension tip A counterclockwise.
1.
Use the number reference B in the leg extension C to adjust
2.
the leg height. Refer to DETAIL "B".
3.
Repeat STEPS 1-2 for the remaining three legs.
NOTE: Make sure that all four legs are adjusted to the same height.
To decrease leg height:
Rotate the leg extension tip A clockwise.
1.
Use the number reference B in the leg extension C to adjust
2.
the leg height. Refer to DETAIL "B".
3.
Repeat STEPS 1-2 for the remaining three legs.
NOTE: Make sure that all four legs are adjusted to the same height.
Invacare® I-Fit™ Shower Chair
B
D
C
E
A
B
WARNING
Installing/Removing the Backrest - Model
9781E Only
Installing
E
D
Before installing the backrest A, attach and adjust the legs so
1.
the shower chair is level and stable. Refer to Attaching the
Legs and Adjusting Leg Extension Height on page 2.
Position the backrest into the slot B in the seat C.
2.
3.
Push down on the backrest until it snaps securely into the slot
in the seat.
4.
Turn the shower chair upside down and look under the seat to
ensure both compression buttons D are fully visible through
the notches E on the back of the seat.
NOTE: If both compression buttons are visible, the backrest is attached
properly. If the compression buttons are not visible, apply pressure to the
backrest until it snaps into the slot in the seat.
Removing
G
D
Locate and depress both compression buttons D with one
1.
hand.
Using the other hand, use the backrest handle F to pull the
2.
backrest A up and disengage it out of the slot B in the seat C.
Using the Shower Chair
Risk of injury. DO NOT lift the shower chair while the user is
seated. The backrest can get loose and injury or damage may
occur.
2
A
E
F
C
WARNING
Part No 1176081
E
B
C
A
B

Advertisement

loading

This manual is also suitable for:

I-fit 9781e