Advertisement
Available languages
Available languages
Troubleshooting
.
The trimmer does not work when it is switched on and none of the lights go on:
1
If the battery is completely empty, the trimmer will not work and the lights will not go on when the appliance is switched on. Charge the
appliance until it is fully charged (also see chapter 'Charging'). Charging will take approx. 10 hours.
If the suction system of the vacuum beard trimmer performs poorly or does not work at all, check the points listed below.
2
Is the hair-collection chamber empty? (fi g. 10).
B
We advise you to empty the hair-collection chamber after each trimming session. When cutting long, dense beards it may also be necessary to empty the
hair-collection chamber during the trimming session.
3
Is the hair-collection chamber or the fi lter wet?
B
Both parts may only be cleaned dry. If one of these parts becomes wet, dry it carefully.
4
Does the fl exible hair guide in front of the cutting unit jam? (fi g. 17).
B
The transparent hair guide needs to be flexible in order to be able to adjust to the contours of the face. If it jams because hairs have got stuck in it, remove
the hairs carefully with the brush supplied. The flexible hair guide should yield at the touch of a finger.
5
Do you move the appliance in the optimal direction? (fi g. 6).
B
For the best possible cutting and suction performance we advise you to move the trimmer upwards, against the direction of hair growth, making smooth and
gentle strokes.
Trimming length settings
Setting
1
2
3
4
5
6
7
8
9
4203 000 31382
Resulting hair length
1.5 mm
2.5 mm
4 mm
5.5 mm
7.5 mm
9.5 mm
12 mm
15 mm
18 mm
4/7
Advertisement
