Download Print this page

Philips QT4040/00 Instructions For Use Manual page 3

Philips beard trimmer

Advertisement

Available languages

Available languages

We advise you to empty the hair-collection chamber after each trimming session. When trimming long, dense beards it may also be necessary to empty
the hair-collection chamber during the trimming session in order to maintain optimal suction performance (also see chapter 'Cleaning', section 'Hair-
collection chamber').
B
To ensure optimal functioning of the vacuum system, do not cut off more than approx. 7mm of your overall beard length at a time. If you want to cut your
beard shorter, repeat the process one or more times.
Trimming with comb attachment
1
Turn the adjustment ring (Precision Zoom Lock`) to the desired trimming length setting (see table) (fi g. 3).
The setting will appear in the window below the adjustment ring (Precision Zoom Lock`).
If you are trimming for the first time, start with the maximum trimming length setting (9).
2
To trim in the most effective way, move the trimmer against the direction of hair growth. Do not move the trimmer too fast. Make smooth and
gentle movements and make sure the surface of the comb always stays in contact with the skin (fi g. 4).
Trimming at the unique 'stubble look' setting
Use the trimmer with the comb attachment set to length setting 1. This allows you to create a 'stubble look' (fig. 5).
Trimming without comb attachment
Full beards and single hairs.
1
Remove the comb attachment (fi g. 6).
B
Never pull at the flexible top of the comb attachment. Always pull at the bottom part.
2
Make well-controlled movements and touch the hair lightly with the trimmer (fi g. 7).
Cleaning
.
The appliance may only be cleaned dry.
Do not use abrasives, scourers or liquids such as alcohol, petrol or acetone to clean the appliance.
Never use sharp or hard objects to clean the filter to avoid damaging it.
Hair-collection chamber
1
Switch the appliance off.
2
Remove the hair-collection chamber and remove the hairs by shaking or brushing them out (fi g. 8).
3
For extra thorough cleaning and to maintain optimal suction performance, detach the fi lter... (fi g. 9).
4
...and carefully clean the hair-collection chamber and the fi lter with the brush supplied (fi g. 10).
Appliance
1
Remove the comb attachment.
2
Remove the cutting unit (fi g. 11).
3
Clean the cutting unit and the inside of the appliance with the brush supplied (fi g. 12).
4
Reattach the cutting unit and the comb attachment to the appliance (fi g. 13).
Replacement
.
Worn or damaged cutting units and filters should only be replaced with original Philips replacement parts which are available at your dealer or at
authorised Philips service centres.
Environment
.
Do not throw the appliance away with the normal household waste at the end of its life, but hand it in at an official collection point for recycling.
By doing this you will help to preserve the environment (fig. 14).
The built-in rechargeable battery contains substances that may pollute the environment. Always remove the battery before discarding the appliance or
handing it in at an official collection point. Dispose of the battery at an official collection point for batteries. If you have trouble removing the battery, you
can also take the appliance to a Philips service centre, which will remove the battery for you and will dispose of it in an environmentally safe way.
Removing the battery
Do not connect the appliance to the mains again after it has been opened.
Follow the steps below to remove the battery.
1
Disconnect the appliance from the mains and let the appliance run until the motor stops.
2
Separate the two housing parts by means of a screwdriver (fi g. 15).
3
Pull out the printed circuit board (fi g. 16).
4
Remove the rechargeable battery by means of a screwdriver and detach it by bending or turning it several times until the connections break
(fi g. 17).
5
Dispose of the battery and the other components in an environmentally safe way.
Do not connect the appliance to the mains again after it has been opened.
Guarantee & service
.
If you need information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Customer Care Centre in
your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local
Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV.
4203 000 31382
3/7

Advertisement

loading

This manual is also suitable for:

Qt4060/60Qt4040/60Qt4060/00Qt4040Qt4060Tt4040/60