Product Information; Troubleshooting - Philips CEM200/55 User Manual

9 Product
information
Note
Product information is subject to change
without prior notice.
Power supply
Fuse
Suitable speaker
impedance
Maximum power
output
Continuous power
output
Pre-Amp output
voltage
Aux-in level
Dimensions
(W x H x D)
Weight
Radio
Frequency range - FM
Frequency range
- AM(MW)
Usable sensitivity
- FM
Usable sensitivity
- AM(MW)
(S/N = 20 dB)
12 V DC (11 V - 16 V),
negative ground
15 A
4 - 8
45 W x 4 channels
22 W x 4 RMS
(4 10% T.H.D.)
2.0 V
500 mV
188 x 58 x 206 mm
1.57 kg
87.5 - 108.0 MHz
(100 kHz per step
in auto search and
50 kHz per step in
manual search)
522 - 1620 KHz
(9 KHz)
530 - 1710 KHz
(10 KHz)
8 µV
30 µV

10 Troubleshooting

Caution
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/support). When you contact Philips,
ensure that your apparatus is nearby and the
model number and serial number are available.
No power or no sound.
Car engine is not on. Turn the car engine
on.
Cable is not correctly connected. Check
connections.
Fuse is burnt. Replace fuse.
Volume is too low. Adjust volume (see
'Adjust volume' on page 17).
If the above solutions cannot help, press
the RESET button.
Ensure that the track played is of a
compatible format.
Noise in broadcasts.
Signals are too weak. Select other
stations with stronger signals.
Check the connection of the car antenna.
Change broadcast from Stereo to mono.
Cannot play disc
Ensure that the disc label is inserted with
the printed side facing up.
from the centre to the edge in a straight
line.
This disc may be defective. Play another
disc.
R/CD-RW.
Ensure that the CD is not encoded with
copyright protection technologies.
EN 21