How To Assemble Your Vacuum Cleaner - Eureka 95 Owner's Manual

How to assemble your vacuum cleaner

Fig. 1
G
M
Fig. 2
I
O
L
Fig. 3
I
Fig. 4
Assemble completely and charge batteries for 14-16
hours before using.
CAUTION : Use only Eureka model JOD-S-100020A5-C-3
charger. Have a screwdriver available for assembly (not
included).
H
Attach Handle Grip
Step 1: Locate the 2-part bolt
Step 2: Align the handle grip and handle tube holes and
Attach Handle
Step 1: Use your thumb to pull back on the lock button
Step 2: Push handle
Step 3: Release lock button
Secure Wall Bracket on Wall
Have a 1/4 inch drill available for assembly (not included).
Cleaner hangs in bracket with the nozzle end down. Mount
on a wall in close proximity to an electrical outlet where
there are not dangerous objects hidden beneath the wall
surface like electrical wires, pipes, etc. Leave 14 inches
above the floor for clearance.
Step 1: Hold bracket
N
Step 2: Use a 1/4 inch drill for drilling holes for the plastic
Step 3: Insert the anchors
Step 4: Tighten the screws
Step 5: Place cleaner, with the nozzle pointed down, on the
Step 6: Plug the charger
Note: This charger has been designed to use as either
P
secure with the 2-part bolt
Note: The single hole in the handle tube faces
forward in relation to the handle grip.
(Fig. 2)
into top of cleaner.
G
locks into place.
against wall to mark location for
I
screws. Make sure the wall bracket is positioned
vertically, with the charger socket at the bottom.
anchors .
N
both holes.
wall bracket .
I
a wall mounted charger or to sit on a counter or
shelf . To use on a counter or shelf, locate next
P
to an electrical outlet. Take the battery
the cleaner and put in the counter bracket
charge light indicates power on to
J
is charging (Fig. 4).
(Fig. 1)
in the assembly package.
H
. Tighten the bolt
H
and rotate handle
M
and drive the screws
N
to secure the bracket
O
in to an electrical outlet.
L
www.eureka.com
.
M
until it
G
(Fig. 3)
into
O
.
I
out of
C
. The
I
the battery
K
5