End Of The Programme - Electrolux EW7F3846HS User Manual

24 www.electrolux.com
Once removed the exceeding garments,
touch the Start/Pause
the programme again. The SensiCare
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The SensiCare detection is
carried out with complete
washing programmes only
and if the programme
duration has not been
reduced by means of the
Time Manager button.
10.9 Interrupting a programme
and changing the options
When the programme is running, you
can change only some options:
1. Touch the button Start/Pause
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the button Start/Pause
again.
The washing programme continues.
10.10 Cancelling a running
programme
1. Press the button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press the button On/Off again to
activate the appliance.
button to start
There is also an alternative way of
cancelling:
1. Rotate the selector knob to the "Reset"
position
2. Wait for 1 second. The display shows
Now, you can set a new washing
programme.

10.11 End of the programme

When the programme has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active). The display shows
The indicator of the Start/Pause
.
button goes off.
The door unlocks and the indicator
goes off.
1. Press button On/Off to deactivate the
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
2. Remove the laundry from the
3. Make sure that the drum is empty.
4. Keep the door and the detergent
5. Close the water tap.
If the SensiCare System has
completed and the water
filling has already started,
the new programme starts
without repeating the
SensiCare System. The
water and the detergent are
not drained out in order to
avoid waste. The display
shows the maximum
duration of the programme,
updating it about 20 minutes
after the starting of the new
programme.
.
.
appliance.
When you activate the
appliance again, the display
shows the end of the
previous programme. Turn
the programme dial to set a
new cycle.
appliance.
dispenser slightly ajar to prevent
mildew and odours.