Connections - Bush DLED43287FHDDVD Instruction Manual

Connections

Bringing it all together
Connections
Connector
Connection
Connection
SIDE AV
PC/YPbPr
Connection
Connection
SPDIF
(Optical Out)
Connection
SIDE AV
Side AV
(Audio/Video)
Connection
HEADPHONE Headphone
Connection
YPbPr Video
PC to YPBPR
Connection
Connection
Connection
LAN
Ethernet
Connection
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
14 Connections
Type Cables
Scart
(back)
VGA
(back)
Audio
YPbPr/PC Audio Cable
(side)
HDMI
(back)
SPDIF
(back)
AV Cable
(side)
(side)
(back) PC to YPbPr Connection Cable
USB
(side)
CI
(side)
LAN / Ethernet Cable
(back)
NOTE: When connecting a device via
Device
the YPbPr or Side AV input, you must
use the connection cables to enable
connection. See the illustrations on
the left side. You can use YPbPr to
VGA cable to enable YPbPr signal via
VGA input. You cannot use VGA and
YPbPr at the same time. To enable PC/
YPbPr audio, you will need to use the
side audio inputs with a YPbPr/PC
audio cable for audio connection.
If an external device is connected
via the SCART socket, the TV will
automatically switch to AV mode.|
When receiving DTV channels (Mpeg4
H.264) or while in Media Browser
mode, output will not be available via
the scart socket. When using the wall
mounting kit (available from third
party in the market, if not supplied),
we recommend that you plug all
your cables into the back of the TV
before mounting on the wall. Insert or
remove the CI module only when the
TV is SWITCHED OFF. You should refer
to the module instruction manual for
details of the settings. The/Each USB
input of your TV supports devices up
to 500mA. Connecting devices that
have current value above 500mA
may damage your TV. By connecting
an HDMI cable to your TV, you have
to use only a shielded HDMI cable
to guarantee a sufficient immunity
against parasitic frequency radiation.
If you want to connect a device
to the TV, make sure that both
the TV and the device are turned off
before making any connection. After
the connection is done, you can turn
on the units and use them.